Bit of an odd request, but only just noticed it. Since getting active on 4M I have started using an FT-817 and a transverter, which works well. I can set an offset for the rig control window so I know where I am in the band.
I've just had to change the crystal in the transverters oscillator and as a result of not hvaing an exact frequency I now need to offset of 75.125MHz. When I set this it works fine, until I close winlog and re-open, at which point it reverts to 75MHz.
Is it possible for it to support non integer numbers in te transverter offset I wonder? If not then I shall have to make sure I don't forget to account by hand
Cheers for the great software Colin
Iain M0PCB
73, Iain M0PCB/M1ETJ
Transverter offsets...
Transverter offsets...
Hi Iain
I had not envisaged an odd offset so thanks for bringing this to my attention, it will not be too much of a problem to enable non-integers to be saved.
I will attend to this as soon as possible, please can you email me directly so that I can reply with a 'fix' for this particular problem.
73 Colin G0CUZ
Winlog32 Author
I had not envisaged an odd offset so thanks for bringing this to my attention, it will not be too much of a problem to enable non-integers to be saved.
I will attend to this as soon as possible, please can you email me directly so that I can reply with a 'fix' for this particular problem.
73 Colin G0CUZ
Winlog32 Author