756pro3 and civ

You may post here if you are having problems with Winlog32 that others may be able to help you with. You may also report bugs so that the author may act upon them.
Post Reply
k2mme
New user
Posts: 1
Joined: Tue Nov 27, 2018 9:21 pm

756pro3 and civ

Post by k2mme » Tue Nov 27, 2018 9:31 pm

Hi
I am trying to get winlog32 amd my 756pro3 and ic7300 to get the software to read frequncy and mode etc. I am missing something. Got baud rate,com port set al. What am I missing?

G0CUZ
Site Admin
Posts: 1642
Joined: Wed Jan 02, 2002 7:12 am

Re: 756pro3 and civ

Post by G0CUZ » Thu Nov 29, 2018 9:56 am

Do you not have any response at all in the Winlog32 Rig Control Window or from the rig when commanding from the RCW?

If not :
-Have you set the correct CI-V address for you rig as these values must match on rig and RCW.
Also the Virtual Com Port driver must be installed for the cable you are using.

Usually there is no problems with Icom C-IV, all rigs use the same protocol.

If you do have some sort of response between rig and RCW, then there is usually a setting in the rig CI-V menu called something like "Transceive" or "TRAN", this setting must be ON, as this setting broadcasts the freq/mode when the rig is tuned, as no polling takes place on the Icom interface.

73 Colin, G0CUZ

Post Reply