I have Winlog32 set up and working on my Flex 6300. Previously it picked up the correct frequency from the Rig and entered it into the proper field in the log. I had set it up to enter something like 14.321 and that worked correctly. After I updated to a new level of Winlog32, the rig frequency is showing correctly in the rig window, but it is always logged as 14.000 rather than 14.321 and I can't seem to get the KHz part to be anything but zeros. I have "enable KHz" set. Can anyone advise how to fix this?
Paul
Frequency retrieval from rig
Re: Frequency retrieval from rig
Hi Paul
There are two settings for this.
1. Winlog32/Menu/Options - 'Allow KHz' = enable.
2. Rig Control Window - settings - tab Options -'Add Full Frequency to Log' = enable.
Then it should work as expected.
73 Colin
G0CUZ
There are two settings for this.
1. Winlog32/Menu/Options - 'Allow KHz' = enable.
2. Rig Control Window - settings - tab Options -'Add Full Frequency to Log' = enable.
Then it should work as expected.
73 Colin
G0CUZ
Re: Frequency retrieval from rig
OK Colin, #2 fixed it. I just couldn't find it. Thanks
Paul
Paul