New to PC Logging. Should the full rig frequency show in the MHz box (under the Start Time) when using CAT. Rig is talking to the PC OK but only shows frequency/frequency changes in the sub panel.
Mike
FT1000mp MkV CAT setting up
-
- Bit of a boffin
- Posts: 67
- Joined: Wed Jan 09, 2002 5:09 am
- Location: Stuttgart, Germany
- Contact:
Re: FT1000mp MkV CAT setting up
Hi Mike,
If you log a new contact the MHz box will be filled after hitting the "enter" key if the cursor is in the MHz box. If you are playing with the vfo knob on your TRX you see the changing frequency in the CAT window, but the MHz box stays empty. All fields in the QSO window work the same way. You must hit the "enter" key to fill the fields.
I hope I understood your questions right.
If you log a new contact the MHz box will be filled after hitting the "enter" key if the cursor is in the MHz box. If you are playing with the vfo knob on your TRX you see the changing frequency in the CAT window, but the MHz box stays empty. All fields in the QSO window work the same way. You must hit the "enter" key to fill the fields.
I hope I understood your questions right.
73 de Gerald - DL4KG
Re: FT1000mp MkV CAT setting up
Hi Gerald,
Many thanks for your reply. Yes, you understood the question. I have tried your suggestion previously (and again tonight)
Hitting the END button does not fill in the frequency in the Mhz box and the log page shows blank entries.
Regards
Mike
Many thanks for your reply. Yes, you understood the question. I have tried your suggestion previously (and again tonight)
Hitting the END button does not fill in the frequency in the Mhz box and the log page shows blank entries.
Regards
Mike
Re: FT1000mp MkV CAT setting up
Hi Gerald,
Hello again, many thanks once more for your reply. Problem is now sorted.
73
Mike G0CHV
Hello again, many thanks once more for your reply. Problem is now sorted.
73
Mike G0CHV