Page 1 of 1

Icom 7300 Tx-ing

Posted: Thu Nov 22, 2018 1:03 am
by JohnnyGM7LSI
Hi to All, I have just installed Winlog32 on Win 10 but when I load up Winlog32 my Icom 7300 goes into TX mode, Many thanks, Johnny.

Re: Icom 7300 Tx-ing

Posted: Thu Nov 22, 2018 5:35 am
by SV1GRB
Hi Johnny,

I suppose that the RTS and/or DTR PTT function is enabled in the CONNECTORS menu of the transceiver.

You should disable this RTS/DTR function, or if you need this for some other program, you can uncheck the "Enable RTS" and "Enable DTR" in Rig settings of Winlog32 (Menu Rigs->Icom CI-V rig#->Settings->Settings).

Icom does not need any constant voltage on this pin to provide power to circuits and does not use flow control either. So RTS and DTR are not needed.

73
Haris
SV1GRB

Re: Icom 7300 Tx-ing

Posted: Thu Nov 22, 2018 9:01 am
by JohnnyGM7LSI
Hi Haris, Many thanks for that, that fixed it, now to get the freq to read out, I`ve been using HRD far too long and Winlog32 was suggested by another ham.

Thanks again, 73 Johnny GM7LSI.