Hi all (and season's greetings).
I am using my Elecraft KX3 (also have a K2) and wonder if there are any differences with the "K3" settings ?
The "Initialise" button works only ...sometimes.
Any info on this setup is welcome.
Winlog32 is launched via LPB2, which gives me access to NaP3 (working flawlessly), and soon Fldigi, WSJT-X, WSPR.
72 de Jean-Marc, F5LCI
KX3
KX3
I found that with my KX3 connected and the K3 settings that the frequency display showed VFOB in Winlog32 rather than VFOA.
I don't think there are any major differences in the CAT commands, but what differences there are a subtle and seemingly affect some functions.
Looking forward to v6, been using Winlog32 here for around 12 years, still the best logging program I can find. Keep up the good work Colin.
73, Iain M0PCB
I don't think there are any major differences in the CAT commands, but what differences there are a subtle and seemingly affect some functions.
Looking forward to v6, been using Winlog32 here for around 12 years, still the best logging program I can find. Keep up the good work Colin.
73, Iain M0PCB
KX3
Interestingly I tried my KX3 using the K2 settings and everything works fine, in terms of the main frequency read-back is that of VFOA and not VFOB.
Just about to install the new version, thanks for your ongoing support Colin.
73, Iain M0PCB
Just about to install the new version, thanks for your ongoing support Colin.
73, Iain M0PCB
KX3
I did find that 'K3' type was not enabled correct in Kenwood RCW #2 although this was OK in Kenwood RCW #1, this would mean that KX3 or K3 would not be correct when K3 selected in RCW#2 (although it would be OK in RCW#1)
It would explain some of the differences guys are having with K3 or KX3.
So best bet until it is fixed is to select K2.
73 Colin
G0CUZ
It would explain some of the differences guys are having with K3 or KX3.
So best bet until it is fixed is to select K2.
73 Colin
G0CUZ