Log check robot
Posted: Mon Apr 17, 2017 1:15 pm
Hi Colin,
Is there any way to make the log check robot go through the "Mode" and perhaps the "Prop" fields to update any changes in the logs and have them recorded in the database?
This question comes from the following scenario: I have imported a number of QSOs from the old DOS Fastlog using an AIDF convertor. Winlog32 imported these QSOs seamlessly. A number of digital modes were not born yet when Fastlog was created so as the years went by, I had posted these under the generic "PKT" packet mode as this was the only one available. In Winlog32 however it is possible to assign any mode to any QSO by updating the custom list. I went through the imported log and manually updated every QSO assigning the proper mode from remarks I had kept. This is quite sufficient really but I wondered if it would be possible to update the info also in say the DXCC database by making the Log Check Robot check through the Mode field.
I believe the same applies to QSOs edited after they have been posted.
Thanks and 73,
Joe
9H1CG - G4GTI
Is there any way to make the log check robot go through the "Mode" and perhaps the "Prop" fields to update any changes in the logs and have them recorded in the database?
This question comes from the following scenario: I have imported a number of QSOs from the old DOS Fastlog using an AIDF convertor. Winlog32 imported these QSOs seamlessly. A number of digital modes were not born yet when Fastlog was created so as the years went by, I had posted these under the generic "PKT" packet mode as this was the only one available. In Winlog32 however it is possible to assign any mode to any QSO by updating the custom list. I went through the imported log and manually updated every QSO assigning the proper mode from remarks I had kept. This is quite sufficient really but I wondered if it would be possible to update the info also in say the DXCC database by making the Log Check Robot check through the Mode field.
I believe the same applies to QSOs edited after they have been posted.
Thanks and 73,
Joe
9H1CG - G4GTI