setting up transceiver cat interface with winlog 32
Posted: Wed May 18, 2016 7:20 am
I have a problem setting up the cat interface with winlog 32. I had hoped I would find the answer on the online help. For some reason this service is not available. I have successfully set up the interface from ZLP Electronics with my pc. The interface is connected to a Kenwood TS870. The com port assigned by windows is comport 9. When setting up the parameters in the "rig settings" of winlog 32 I am assigning comport 9 to the custom settings. This does not seem to be accepted. It defaults to com port 1 which is verified at the programs rig control panel, "error in com port 1". If I go back to settings I see com port 1 is highlighted. Is there a way of resolving this problem.
Thanks
G0oof
Thanks
G0oof