Winlog32 Forums

I'm new to winlog32 and I started entering in some paper logs I had and forgot to put the signal reports in, I tried to go back in and edit them 1 worked ok but I couldn't get the other 2 to change. It says nothing there?

Normally, when you change something in a record and then navigate to another record or hit one of the "<" or ">" or "END" button the changes are written in the database.
There is no "special" procedure in order to edit a record.

73
Haris
SV1GRB

In addition to what Haris says, consider that QSOs are edited in the QSO Input boxes, NOT in the Page View, was this what you were trying to do?

As said, there is no special procedure, once data has been changed it is 'Saved' automatically.

73 Colin, G0CUZ

Ok I went into log search replace, I messed with it and got the QSO fixed. But took some work, Is this the correct way or is there an easier way?

Thanks for the replies

73
Brian

Just click on the QSO in the "log page". You will see all data in the input mask. There you can easily edit all fields. You can go the next QSO just by clicking on the the arrows on the side of the "end" button. That way you move forward or backward to the next QSO in the log page.

If you want to edit a QSO on the log search page do a double click. Than the procedure is the same as described above.

Thanks I understand now.