Hi Colin,
I hope you are well. Here is a quick one for you:
When in speedlog mode, I enter QSO's, but if I am working a new band-mode DXCC or IOTA for instance, I am not prompted by WL32 if I want to update the corresponding ancilliary database. The only solution I found so far is to run the robot over the QSO's I have just made when I decide to stop trafic.
Did I miss something?
Would it be possible to implement such check in next release?
Thanks in advance
73 de Pascal - F5JSD
Anciliary database auto-check in Speedlog mode
Anciliary database auto-check in Speedlog mode
Hi Pascal
The behaviour you mention is deliberate, in speed modes it is assumed that it is used just for that, and that you will not want to stop making QSO's because of pop-ups requiring attention- this can be particuly annoying in pile-ups (not that I get any with my pee-wee station!).
Hope that explains
73 Colin G0CUZ
Winlog32 Author
The behaviour you mention is deliberate, in speed modes it is assumed that it is used just for that, and that you will not want to stop making QSO's because of pop-ups requiring attention- this can be particuly annoying in pile-ups (not that I get any with my pee-wee station!).
Hope that explains
73 Colin G0CUZ
Winlog32 Author
Anciliary database auto-check in Speedlog mode
Hi Colin,
OK, no problem, I understand your point.
Sorry for the late reply.
73 de Pascal - F5JSD
OK, no problem, I understand your point.
Sorry for the late reply.
73 de Pascal - F5JSD